For starters, I recommend that you put out a dynamic saturating color that you can conduct yourself as a more "realistic" background during the process. Then it's time to start putting out the dimensions for the aquarium should behave in a geogramatiskt and proper manner in which to create this professional look where the measurements are considered more realistic (Although you are not my measure it in terms of its bottom). When midges are exposed, it is time to "paint" the aquarium, this is done with white paint, layer should have a transparent blendingmode (I used traditional "overlay") and its opacity should be reduced around 50% to create this transparent glass effect.
Then fill akvariumen with selected gradients and place them over akvariumets stock and set the gradient layer in a mixing layer you see fit and lower the opacity if needed. Note that position the gradient layer using a mask layer.
Then do the same with the middle aquarium and put into the items you want, I chose the vegetables melons and tomatoes to symbolize mines in the picture. Once you have done this you will notice for sure that it's very unrealistic and out to the object rather hmnar outside the aquarium than in it. This fixes quickly and easily by selecting the items you have chosen to use and lower their "Fill" similar opacity's function very much but that lower color saturation much better. By lowering the "Fill" makes items much duller and "transparent" to create this misty water-power and wholla! There you have your water objects in the aquarium.
4. The boat skpar easily with the help of "Pen Tool" omvanldar its path's to selections and fill them with the selected color. This eventually becomes a lot of layers that you can easily put together but I fully recommend that you save the original bearings when permanent changes are what I consider to be forbidden. That is, then you can never go back to change anything, same applies to the use of "eraser-tool", I always try to avoid as many permanent fÃ¶rÃ¤ndirngar as possible this by instead use layer masks. In any case, when the boat is ready, you can always complement the look with its textures as I have done to create a more realistic Additional detail in the picture. Small-network details, finally, a stunning whole.
Then proceed to fill the aquarium with details, I chose to place a piece of land with a life-rich trees. Note that it is still important that the soil platelet is inside the aquarium but is not transparent in the same way as the water, and therefore when the aquariums' back is not visible.
Just continue to adorn the aquarium with the details as I have done, try to also keep an even balance of detail and where the center piece so no page "weighs" more than the other, this also contributes to a professional that the person who made the picture have had a stable control of detail. To go deeper into the details, you find that the woman / girl is swimming in the aquarium? Do you notice that the aquarium is brighter at the bottom than it is at its peak? By lighting up the woman's / girl's belly with yellow shining bright like the bottom of the aquarium, this creates an Additional clearer understanding that the bottom of the aquarium is lit from the bottom up.
Finally, add the final details of the picture and the picture is complete! As a beautiful fÃ¤rgsymetri I chose to use the color yellow in each of the three akvariumen to link the one and a different way in terms of color by creating this balancing triangle.