I placed the table image and removed the window.
step 1 of 10
step 2 of 10
I duplicated the table layer and removed the table.
step 3 of 10
I placed the motor part cut it out and then copied the top. I then warped and tilted them to make a curve.
step 4 of 10
I placed the gun image.
step 5 of 10
Here I cut out the elephant and color corrected the gun
step 6 of 10
I duplicated the elephant layer multiple times and changed the opacity on each layer. I also warped and scaled each layer differently.
step 7 of 10
I used lens flare here to create the beam. I then stretched it and tilted it a bit. I then messed with the hue setting to give it a red color.
step 8 of 10
I added some reflection to the gun from the laser and and also rendered difference clouds to make it look a bit smokey.
step 9 of 10
In this step I added the circuit boards. I gave them an inner glow for shadow and then drew a glare to make it look as though it was coverd by glass.
step 10 of 10
In this step I drew some wires using the pen tool and stroke fills. I then colored each wire and used the bevel and emboss filter on each one.
Final result
Pxleyes
Photography and photoshop contests
We are a community of people with
a passion for photography, graphics and art in general.
Every day new photoshop
and photography contests are posted to compete in. We also have one weekly drawing contest
and one weekly 3D contest!
Participation is 100% free!
Just
register and get
started!
Good luck!
Follow us:
© 2015 Pxleyes.com. All rights reserved.